The Bullet pumps are ideal for dewatering constructions sites, mines, circulating fountain water, or for all around use in industrial plants and utilities.

• Top Discharge – allows for superior cooling of motor and provides a slim line design.
• Longer Power Cord – Standard 33ft. power cord on pumps ½ HP and below and 50ft. on pumps 1HP and above.
• 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic*. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
• Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components*.
• R400D Special Feature – The mode Up Pumps, will pump down to 1/12 th of an inch. It features a special diaphragm value that prevents water backflow.

• Max. Flow: Gpm: 89
• Max. Head: Ft: 49.5'
• Pump Type: Top Discharge, Dewatering
• Strainer Opening: 0.25"
• Discharge Size: 2" NPT-M
• Max. Submerged Depth: 65'
• Shipping Weightibs: 66

• Motor Casing: 304SS
• Pump Volute: Cast Iron
• Impeller - Multi Vane: Cast Iron
• Lip Seals &0-Rings: Buna-N
• Rotor Shaft: 304 SS
• External Hardware: 304 SS
• Oty. Oil In Seal Chamber: 3.7 U.S. FL OZ.

• Motor Rating: Hp: 1
• Motor Rpm: 3450
• Motor Insulation Class: F
• Motor Service Factor: 1.1
• Voltage: 208/230/460/575, 3PH-60HZ
• Motor Protection: Thermal & Amp Overload
• Power Cord: Gage; Length: A.W.G. 16/4; 50', STOW
• Maximum Liquid Temperature: 104° F
• Seal Minder: Not Available