• Max. Flow: Gpm: 240
• Max. Head: Ft: 59'
• Pump Type: Non Clog Shredder
• Discharge Size: 3" NPT-M
• Max. Submerged Depth: 65'
• Min. Submerged Depth: 13.5"
• Shipping Weight:Lbs: 123

• Motor Casing: 304 SS
• Pump Volute: Cast Iron
• Strainer / Stand: Cast Iron
• Lip Seals & O-Rings: Buna-N
• Rotor Shaft: 304 SS
• External Hardware: 304 SS
• Qty. Oil In Seal Chamber: 11.8 U.S. FL. OZ.

• Motor Rating: Hp: 3
• Motor Rpm: 3450
• Motor Insulation Class: F
• Motor Service Factor: 1.1
• Voltage: 208/230/460/575, 3PH-60 Hz
• Motor Protection: Thermal & Amp Overload
• Power Cord: Gage; Length: A.W.G. 14/4; 33', STOW
• Maximum Liquid Temperature: 104° F
• Seal Minder: Standard/Included

Electric Submersible Pumps with Shredder Action Impellers for Municipal, Industrial and Agricultural Waste-Water

The Shredder (SK) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.

• Longer Power Cord – Standard 33ft. power.
• 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
• Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.