• Max. Flow: Gpm: 291
• Max. Head: Ft: 64'
• Pump Type: NON CLOG, SHREDDER
• Discharge Size: 3" NPT-M
• Min. Submerged Depth: 24"
• Shipping Weight:Lbs: 166

• Motor Casing: CAST IRON
• Pump Volute: CAST IRON
• Strainer / Stand: CAST IRON
• Lip Seals & O-Rings: NITRILE BUTADIENE RUBBER
• Rotor Shaft: 403 SS
• External Hardware: 304 SS

• Motor Rating: Hp: 3
• Motor Rpm: 3450
• Motor Insulation Class: F
• Motor Service Factor: 1.15
• Voltage: 208/230/460/575 - 3PH-60Hz
• Motor Protection: TWO NORMALLY CLOSED THERMOSTATS
• Power Cord: Gage; Length: A.W.G 14/4 33', SOOW
• Maximum Liquid Temperature: 104° F

Explosion Proof Electric Submersible Pumps with Shredder Action Impellers for use in Class 1, Division 1, Groups C & D Hazardous Locations

XP-SK Series
The Shredder (SK & XP-SK) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.

• Shredder Pump - with FM Approved motor for use in Class 1, Division 1, Groups C & D hazardous locations. Available in 208, 230, 460 or 575 Volt 60Hz. Contact factory for 50Hz availability.
• Longer Power Cord – Standard 33ft. power.
• Epoxy Coated Motor Housing – Superior two part epoxy to protect the motor from exposure to the surrounding liquid.
• Three Seal Motor Protection - Motor is protected by two independent mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber. Standard elastomers are Buna N (FKM optional).
• More Motor Protection – Air filled motor with winding protection and (NEMA) Class F motor insulation. Seal leakage detector(s) in seal chamber offers early warning should water enter the chamber.
• Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.